100269 - 3400W PORTAbLE INvERTER GENERATOR
CONTROLS AND fEATURES
10
Control Panel
1.
Fuel Valve Knob
–
Used to open and close the flow of fuel to
the engine.
2.
Choke
– Used to start a cold engine.
3.
Engine Switch
– Used to put in START mode or STOP the
generator.
4.
Economy Mode Switch
– Enables/disables automatic idle
control.
5.
Output Indicator Light
– Remains ON during normal
operating conditions. Turns OFF when generator is
overloaded.
6.
Overload Indicator Light
– When ON, generator is
overloaded and power to receptacles is cut.
7.
Low Oil Warning Indicator Light
– When ON, engine will
shut down and not run. Check oil level.
8.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
9.
Ground Terminal
– Consult an electrician for local grounding
regulations.
10.
Parallel Outlets
– Used to parallel two inverters together for
increased power output. (parallel kit sold separately).
RECEPTACLES
A
0
12V DC, 8A
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
B
W
120V AC, 30A Locking (NEMA L5-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
C
A
(2×) 120V AC, 20A (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. Prolonged exposure to engine exhaust can cause
serious injury or death. While charging a device do no place
on the exhaust side of the generator. Extreme heat caused
by exhaust can damage the device, and cause a potential fire
hazard.
1
9
10
8
2
3
4
5
6
7
8
A
b
C
