9
REV 76522-20130325
ENGLISH
76522
ASSEMbly
Your pressure washer requires some assembly . This unit
ships from our factory without oil . It must be properly
serviced with fuel and oil before operation .
If you have any questions regarding the assembly of your
pressure washer, call our help line at 1-877-338-0999 .
Please have your serial number and model number available .
Remove the Pressure Washer from the
Shipping Carton
1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the
pressure washer .
Install the Wheel Kit
You will need the following tools to install the wheels:
• 17 mm wrench OR adjustable wrench (not included)
• Socket wrench with a 16 mm socket (not included)
• Pliers (not included)
1 . Before adding fuel and oil, tip the pressure washer on
it’s side .
2 . Slide the M10x105 wheel bolt through the washer,
sleeve and wheel .
3 . Slide the bolt through the mount point on the frame .
4 . Fasten securely with the M10 nut .
5 . Repeat steps 2-4 to attach the second wheel .
Install the Support leg
1 . Attach the support leg to the pressure washer frame
with cap screws (M8x16) and nuts (M8) .
2 . Tip the pressure washer slowly so that it rests on the
wheels and support leg .
The wheel kit is not intended for over-the-road use .
CAUTION
Connect the battery
1 . Remove the protective cover from the red (+) lead on
the battery .
2 . Attach the red (+) lead to the red (+) terminal on the
battery with the cap screw (M5x12) and secure with
the lock washer (M5) .
3 . Repeat steps 1-2 for the black (–) battery lead .
Install the Handle
1 . Place the handle over the mounting channel on the
frame .
2 . Secure the handle to the frame using the two handle
bolts (M8x45) .
3 . Place a lock nut (M8) on the end of each bolt and
fasten securely . DO NOT over tighten the lock nuts .
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.
