Champion Power Equipment 92207, Руководство пользователя и инструкции по эксплуатации

Страница: 14 / 25

11
REV 92207-20110916
ENGLISH 92207
MAINTENANCE ANd STORAGE
The owner/operator is responsible for all periodic
maintenance .
Complete all scheduled maintenance in a timely manner .
Correct any issue before operating the log splitter .
Improper maintenance will void your warranty .
For service or parts assistance, contact our help line
at
1-877-338-0999 .
NOTE
Never operate a damaged or defective log splitter .
WARNING
WARNING
Engine Maintenance
To prevent accidental starting, remove and ground spark
plug wire before performing any service .
Oil
Change oil when the engine is warm . Refer to the oil
specifi cation to select the proper grade of oil for your
operating environment .
1 . Remove the oil drain plug with a 12 mm socket and
extension .
2 . Allow the oil to drain completely .
3 . Replace the drain plug .
4 . Remove oil fi ll cap/dipstick to add oil .
5 . Add 0 .63 qt (0 .6 L) of oil and replace oil fi ll cap/
dipstick .
6 . Dispose of used oil at an approved waste
management facility .
DO NOT use a garden hose to clean the engine or
log splitter .
CAUTION
Water can contaminate the fuel system and can
enter the engine through the cooling slots and
damage the engine .
Clear the debris from the beam, wedge and end plate .
Use a damp cloth to clean exterior surfaces of the engine
and log splitter .
Use a soft bristle brush to remove excess dirt and oil . Use
an air compressor (25 PSI) to clear dirt and small debris .
Wipe all metal parts with an oily rag to help prevent rust
and corrosion .
Spark Plugs
1 . Remove the spark plug cable from the spark plug .
2 . Inspect the electrode on the plug . It must be clean
and not worn to produce the spark required for
ignition .
3 . Make certain the spark plug gap is 0 .7 - 0 .8 mm
(0 .028 - 0 .031 in .) .
4 . Refer to the spark plug recommendation chart when
replacing the plug .
5 . Carefully thread the plug into the engine .
6 . Use the spark plug tool to fi rmly install the plug .
7 . Attach the spark plug wire to the plug .
Air Filter
1 . Remove the snap-on cover holding the air fi lter to the
assembly .
2 . Remove the foam element .
3 . Wash in liquid detergent and water . Squeeze
thoroughly dry in a clean cloth .
4 . Saturate in clean engine oil .
5 . Squeeze in a clean, absorbent cloth to remove all
excess oil .
6 . Place the fi lter in the assembly .
7 . Reattach the air fi lter cover and snap in place .
Cleaning