Champion Power Equipment 2700 PSI 2.4 GPM, Руководство пользователя и инструкции по эксплуатации

Страница: 11 / 33

Assembly
8 Rev 70002-20080214
Assembly
Your pressure washer requires some
assembly. This unit ships from our factory
without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the
assembly of your pressure washer, call our
help line at 1-877-338-0999. Please have
your serial number and model number
available.
Remove the Pressure Washer
from the Shipping Carton
1. Set the shipping carton on a solid, flat
surface.
2. Remove everything from the carton
except the pressure washer.
3. Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit and vibration
mounts.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheels:
12 mm wrench
Socket wrench with a 12 mm socket
Pliers
1.
Before adding oil to the engine, tip the
pressure washer slowly so that the pump
side is up.
2. Slide the axle through both mounting
brackets.
3. Slide a wheel onto the axel.
4. Place a washer on the end.
5. Install the cotter pin through the hole on
the end of the axle.
6. Carefully bend the legs of the cotter pin
back around the axle.
7. Repeat steps 3-6 to attach the second
wheel.
Install the Support Leg
1. Attach each rubber vibration mount to
the base frame with a cap screw
(M8x20) and lock nut (M8).
2. Tip the pressure washer slowly so that it
rests on the wheels and support leg.
Assemble the Frame
1. Remove the hitch pins holding the
handle and frame end to the base frame.
2. Rotate the handle assembly and insert
the ends into the pump side of the base
frame.
3. Insert the hitch pins and secure each
one with a cotter pin.
4. Insert the frame end into the engine side
of the base frame.
5. Insert the hitch pins and secure each
one with a cotter pin.
Add Engine Oil
CAUTION
DO NOT attempt to crank or start the engine
before it has been properly filled with the
recommended type and amount of oil. Damage
to the pressure washer as a result of failure to
follow these instructions will void your warranty.
1. Place the pressure washer on a flat, level
surface.
2. Remove oil fill cap/dipstick to add oil.
3. Add 0.63 qt (0.6 L) of oil and replace oil
fill cap/dipstick.
4. Check engine oil level daily and add as
needed.
CAUTION
The engine is equipped with a low-oil-shutoff and
the will stop when the oil level in the crankcase
falls below the threshold level.
NOTE
Check oil often during the break-in period. Refer
to the Maintenance section for recommended
service intervals.