100734 - LEAf BLOwER
ASSEMBLY
11
ASSEMBLY
Your blower requires some assembly. If you have any
questions regarding the assembly of your blower, call our
Technical Support Team at 1-877-338-0999. Please have your
serial number and model number available.
1. Assemble the upper blower tube to the blower housing by lining
up the arrows on the housing and tube. Slide the peg into the
locking groove and rotate clockwise to lock in place.
2. Assemble the lower tube to the upper tube by aligning the
arrows on the tubes. Slide the peg into the locking groove
and rotate clockwise to lock in place.
OPERATION
fueling and Refueling
Fuel Mixture
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil in a 50:1 ratio. Pre-mix
unleaded gasoline and 2-cycle engine oil in a clean container
approved for gasoline. DO NOT mix quantities larger than usable
in a 30-day period. Recommended fuel: This engine is certified
to operate on unleaded gasoline intended for automotive use.
When mixing fuel, always use clean, fresh, regular unleaded
gasoline with minimum octane rating of 85 and an ethanol
content of 10% or less by volume. DO NOT USE E15 or E85.
Recommended oil: Use premium 2-cycle oil, or an equivalent
high-quality synthetic 2-cycle oil. Do not use automotive oil or
2-cycle outboard oil.
Gasoline (US gal.)
Oil (oz.)
1
2.6
2.5
6.4
3.0
7.7
4.0
10.2
5.0
12.8
Gasoline (L)
Oil (ml)
3.8
76.9
9.5
189.3
11.4
227.7
15.1
301.7
18.9
378.5
filling the fuel Tank
1. Place the blower on a flat stable surface, with the fuel tank
cap facing upwards.
2. Clean the surface around the fuel cap to prevent
contamination.
3. Loosen the fuel cap slowly by turning counterclockwise.
4. Pour the fuel mixture carefully into the tank.
5. Only fill the fuel tank to 80% of the full capacity. Fuel level
can be seen via the clear fuel tank.
6. Clean and inspect the fuel cap gasket before replacing the
fuel cap.
7. Replace the fuel cap and tighten it by turning it clockwise.
8. Wipe spilled fuel from the product.
9. If you spill fuel on the unit, wait 10 minutes after wiping
before starting.
10. Move at least 30 ft. away from refueling area before
starting the product.
NOTE:
It is normal for smoke to be emitted from a new engine
during first use.
