6
Using the Configurator software:
Installation
Unzip the file to the desired place on your drive. You do not have to actually install the
file, so unzip it to the final destination.
Operation
Plug the HMI into your MAC or PC with a micro USB cable (not included). The driver
should auto install. Mobil devices and tablets are not supported.
Then
Open the Configurator
software by double clicking on “MIDIWidgetConfigurator1.0.0.exe”.
Under MIDI Port Setup set both selections to “MIDI Widget” (HMI).
In the light green box click (R)ead configuration from MidiWidget. This will load the
current HMI settings. The HMI uses only outputs 16-23. 16 is Cln, 17 Od1, etc.
If you want to set the output modes to a different setting, you can, but we only support
the default settings. If you have a question you can E-mail us, but we are limited in our
help. A file containing the factory default configuration is available on our website under
the support section.
Editing Presets
The bottom grey box has a matrix. In Fig. 1a we can see preset 0 is Cln with Rvb and
Preset 1 is Od1 only. Preset 3 is Od2 with Rvb. Preset 4 is Od2 only. Preset 5 is Cln
with Sw output 1 “tip” selected. Once you have the settings how you like them go back up
to the top light green section and click (W)rite configuration to MIDIWidget. This will store
the selected configuration to the HMI. This is a great feature if you have a MIDI controller
that can only do program changes. We mentioned earlier how some controllers like the
Rocktron Midi Mate™ are limited to only 5 of the 8 output states on the HMI, but by editing
the presets in the Configurator
software you can sidestep this limitation. Even a Behringer
FCB1010™ will work great now, as will a Tech 21 MIDI Mouse™.
Notes about the software
In Windows 7 (and maybe Mac too);
The scroll wheel on your mouse will not work until you make sure the Configurator
Software is
the ACTIVE window by clicking the top bar of the window. If you click out of the window
you will have to repeat this process.
The “X” to quit the program is greyed out. To end the program click “File” “Exit”.
™
™
™
www.ChampionPedals.com
Fig. 1a
™