CHA HYBRID - MINI / MICRO
Page 11
Plate 3. Hybrid Micro Electrical and Mechanical
Connections.
6.
Connect a CHA RFI CHOKE and coaxial cable or
the Integrated RF Choke end of the CHA Coaxial
Cable assembly to the UHF Socket (g) on the
Hybrid Micro Base.
Raise the Antenna.
7.
Using a Bowline or similar knot, tie the end of a
long length (25 feet or more) of Paracord to the
Carabiner.
8.
Using a throw weight or other method, loop the
Paracord over the support that is closest to
where the radio set will be located.
9.
Raise the Hybrid Micro Base end of the antenna
to a height of 10 to 12 feet and secure it to the
support using a Round Turn and two Half
Hitches, or similar knot.
10.
Using a Bowline, or similar knot, tie another long
length of Paracord to the Isolation Loop at the
end of the Antenna Wire.
11.
Using a throw weight, or some other method,
loop the Paracord over the other support.
12.
Raise the end of the Antenna Wire to a height of
10 to 12 feet, such that the Antenna Wire is not
quite taut, and secure it to the support using a
Round Turn and two Half Hitches.
Extend the Counterpoise.
13.
If using a counterpoise, extend it along the
ground under the antenna.
14.
Perform operational test.
Sloping Wire
The CHA MPAS Sloping Wire configuration, see figure (4), is a broadband short to medium range HF antenna. It is a
good general-purpose antenna, which provides acceptable ground wave and sky wave propagation, and can be
Figure 4. Sloping Wire Configuration.
Содержание CHA MPAS
Страница 2: ...CHA HYBRID MINI MICRO Page 2...
