34
Operation
Motion Detecting Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls
while still allowing activation from the door control and keyless entry. This feature is useful for added
peace of mind when the home is empty (i.e. vacation).
l
Activate:
Press and hold the LOCK button for 2 seconds. The command LED will flash as long
as the lock feature is activated and your handheld remote control will not operate your door at
this time.
l
Deactivate:
Press and hold the LOCK button again for 2 seconds. The command LED will stop
flashing and normal operation will resume.
TIMER-TO-CLOSE
DO NOT enable TTC if operating a one-piece door.
The TTC can be turned on or off and the time
interval can be adjusted to 1, 5, and 10 minute intervals. Once the TTC has been set and the door is
open, the selected close interval will blink and begin to count down to close the door.
l
Activate:
Press and hold the ON button until one of the TTC LEDs light up. Then press the ON
button again to cycle through the time interval options (the corresponding TTC LED will light for
each time interval). The garage door opener light bulbs will blink as confirmation.
l
Deactivate:
Press and hold the OFF button until all TTC LEDs turn off and a beep is heard from
the motor unit.
l
Temporarily hold door open (suspend TTC):
Press and release the HOLD OPEN button. Press
the HOLD OPEN button again to resume normal TTC operation.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ
®
accessories can be programmed to the
garage door opener by pressing the Learn button.
ON (TTC)
OFF (TTC)
Command LED
Motion Sensor
Switch
LIGHT
Button
HOLD OPEN
Button(TTC)
Motion
Sensor
Push Bar
1, 5, and
10 Minute
TTC LED
LEARN Button
LOCK Button
Remote
Control
Your
remote
control
has
been
programmed
at
the
factory
to
operate
with
your
garage
door
opener.
Older
Chamberlain
remote
controls
are
NOT
compatible,
see
page
for
compatible
accessories.
Programming
can
be
done
through
the
door
control
or
the
learn
button
the
garage
door
opener.
To
program
additional
accessories
refer
to
the
instructions
provided
with
the
accessory.
If
your
vehicle
is
equipped
with
HomeLink
®
,
a
Compatability
Bridge
TM
(not
included)
may
be
necessary
for
certain
vehicles.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE MOTION-DETECTING CONTROL PANEL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3.
Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad.
Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been
programmed. Repeat the steps for programming additional remote controls or keyless entry devices.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
?
?
?
?
3
