Single-Function
Remote Control
Push Button
Green Battery
Indicator Light
Multi-Function
Remote Control
Select a Remote
Push Button
Green Battery
Indicator Light
Garage Door Opener
(With "Smart" Button)
"Smart"
Button
Indicator
Light
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door control or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
33
Your garage door opener receiver and remote control
transmitter(s) have been set at the factory to a
matching code. Models having multi-function remote
controls will activate when the
large button on
remote(s) is pressed. The multi-function remote(s)
can also activate additional garage door openers
and/or light control models 874CB and 872CB.
Below are instructions for programming your opener
to match the other buttons on your multi-function
remote and any additional remotes you may
purchase. See available accessories on page 38.
Your "Smart" garage door opener will operate with up
to four "Smart" remote controls (with green indicator
lights), a Keyless Entry System and code switch
remote controls with red indicator lights.
To Add A Remote Control
With a multi-function remote, select a push button to
operate the receiver. See Figure 1.
1. Press and
hold the remote push button.
2. Then press and release the "Smart" button on the
back panel of the opener, Figure 2. The opener
lights will
flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will not
accept the code.
To Change the Selected
Push Button on the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you need
to erase
all the learned codes and reprogram each
remote used to operate the garage door opener.
To Erase All Remote Control Codes
• Press and hold the "Smart" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1 - 3 for each remote
control in use.
Code programming instructions are also located
on the opener panel.
Figure 1
Figure 2
WARNING
Receiver and Remote Control Programming
To comply with FCC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the
code setting or replacing the battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
