Children operating or playing with a garage door opener
can injure themselves or others.
The garage door could
close and cause serious injury or death. Do not allow
children to operate the door control(s) or remote control
transmitter(s).
A moving garage door could injure or kill someone under
it. Activate the opener only when you can see the door
clearly, it is free of obstructions, and is properly adjusted.
WARNING
NOTICE: To comply with FCC/IC rules, adjustment or modification of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the transmitter battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
SECURITY
✚
Garage Door Opener
Smart (learn)
Button
Indicator
Light
+
+
3
2
1
Kg
Kg
1
3
8
7
5
1
3
8
7
5
33
Figure 2
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open when
you press the LARGE remote control push button. The
code between the remote control and the receiver
changes with each use, randomly accessing over 100
billion new codes.
Your
SECURITY
✚
opener will operate with:
• several
SECURITY
✚
remote controls (with yellow
indicator lights) utilizing up to 8 functions.
• one
SECURITY
✚
Keyless Entry System.
Follow the instructions below to program your opener to
match any additional remotes you may purchase. See
Accessories on page 38.
To Add A Remote Control
With a multi-function remote, select a push button to
operate the receiver, See Figure 1.
1. Press and hold the remote control push button.
2. Press and release the “Smart” (learn) button the right
side panel of the opener. See figure 2. The indicator
light on the panel will begin to blink and the opener
lights will flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed. Test by pressing the remote
button to see that the door goes up and down.
Adding a remote can also be done from the door
control as follows:
1. With the door closed, press and hold a remote control
push button.
2. Press and hold the Light button on the door control.
3. Press and hold the door control push bar.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the Smart button on the opener panel until
the indicator light turns off (about 6 seconds). All remote
control codes are now erased. Then follow the steps
above to re-program each remote control.
Code programming instructions are also located on
the opener panel.
To Control the Opener Lights
With
SECURITY
✚
transmitters, a remote push button
can be programmed to operate the opener lights without
opening the door.
1. With the door closed, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
Receiver and Remote Control Programming
SECURITY
✚
Multi-Function Remote Control
Select a Remote
Push Button
Figure 1
