2
LOGIC 2
To Program open Mid-Stop:
1. Close the door.
2. Set dip switches to "Set Mid-Stop".
3. Press open (the door will begin moving).
4. Press stop when the desired Mid-Stop height is reached.
5. Return the dip switches to the desired wiring type (C2, B2,
etc.). The door will now stop at this height every time the door
is opened.
WARNING DEVICES MODULE
LOAD
R7
D3
D4
1
+5V +24V
OUT
+24VDC
D2
Q2
K2
R4
3
2
1
R2
Q1
D1
R6
Q3
C1
R8
C2
K1
J1
10
8
4
3
1
TB1
R8
R9
R1
R3
R5
13
+
TB2
RED
LT
.
GREEN
LT
.
120V IN
L1 L2
Figure 1
Light
Light box conduit w/wires
Power LEDs
24 Vdc for Horn/Strobe
115 Vac power only
SET
MID-STOP
ON
OFF
STEP 5: (FIGURE1)
Complete wiring connections as follows:
• Connect red wire to red light terminal on the Red/Green Light
Control Module connector.
• Connect black wire to green light terminal on the Red/Green
Light Control Module connector.
• Connect white wire to L1 (NEUTRAL) on the power terminal
strip.
• Connect black jumper from L2 (HOT) on the power terminal
strip to (120V IN) terminal on the Red/Green Light Control
Module connector.
STEP 6:
Install red and green light bulbs (not provided). Maximum
wattage should not exceed 75 watts.
OPTIONAL MID-STOP PROGRAMMING:
LOGIC 3
To Program open or down (close) Mid-Stop:
1. Open the door to set close Mid-Stop or close door to set open
Mid-Stop.
2. Turn selector dial to “PROGRAM.”
3. Press the “MID SET” button on logic board.
4. Press the OPEN button for open Mid-Stop, wait until the door
reaches the desired Mid-Stop height, then press the STOP
button.
OR
Press the CLOSE button for down Mid-Stop, wait until the
door reaches the desired Mid-Stop height, then press the
STOP button.
5. Press the MID SET button to complete programming.
6. Turn selector dial back to desired wiring type.
1
2
3
4
1
2
3
4
Green
Light
Red
Light
Red
Red
White
White
Black
Black
