9
Assemble the Rail (continued)
3. Attach rail support braces to the back rail. Loosely insert
1/4-20x7/16" hex bolts into the aligned holes of the end
rail and rail support brace (Figure 1). Do not finger
tighten.
4. Extend the drive screw a few inches from the center rail,
and slide the sleeve onto the long journal (Figure 2).
5. Interlock the long and short journal of the center and
back rails. Slide the sleeve over the journal connection
(Figure 3).
6. Place the c-clip onto the long journal shaft (center rail) to
ensure that the sleeve does not slide (Figure 4).
7. Slide the center rail so that the center rail and rail brace
holes are aligned (Figure 5). Secure with bolts.
8. Tighten all hex bolts.
9. Repeat steps 3-8 for header section.
Metal Sleeve
C-Clip
Hex bolt 1/4-20x7/16"
HARDWARE SHOWN ACTUAL SIZE
Rail Support Brace
Rail Support Brace
Rail
Figure 1
Metal Sleeve
C-Clip
Figure 4
Center Rail
Center Rail
Figure 5
Rail Support Brace
Long Journal
Short Journal
Figure 3
Rail Support Brace
Metal Sleeve
Metal Sleeve
Long Journal
Drive Screw
Center Rail
Figure 2
