Copyright © 2012 Alarm.com
|
www.alarm.com
|
v5.0
3
LiftMaster MyQ
|
Installation Guide
8)
After the yellow light is on at the internet gateway, go to the
MyQ Control Panel (888LM) and push the learn button
twice
. The LED on the gateway will turn blue once the device
is learned in.
9)
Select “Get Equipment List”. This will retrieve the MyQ
Control Panel and link it to the Alarm.com system.
Option 2: Register the Gateway from the Alarm.com Customer
Site
1)
Make sure that the LiftMaster add-on has been added to the
customer’s service plan.
2)
Log into
www.alarm.com
by using customer credentials.
3)
Access garage door registration through emPower -> Garage.
4)
Follow the instructions to add a gateway.
5)
Enter the serial number of the Gateway and continue
6)
Select Add New Device to put the Gateway into learn mode.
7)
After the yellow light is on at the internet gateway, go to the
MyQ Control Panel (888LM) and push the learn button
twice
. The LED on the gateway will turn blue once the device
is learned in.
8)
Return to the Garage page and click “Check for New
Devices”.
9)
Repeat steps 6-8 if initially unsuccessful. Also check the
model number of your garage door against the complete list
of compatible garage door openers below and make sure the
garage door is compatible.
Troubleshooting
1)
If the yellow command LED does not turn on, reverse the
wires connected to the R and W terminals of the control
panel. Replace the wire if necessary.
2)
If yellow and red LEDs are blinking slowly, the control panel is
not compatible with your garage door opener.
3)
If the yellow and red LEDs are blinking quickly, the control
panel is charging, and may take up to 5 minutes to become
operational.
4)
MyQ gateway “Learn Mode” is active for 3 minutes during
which time devices associated with that gateway will be
inoperable.
Factory reset the Internet Gateway:
If you must force a full factory reset (a non-recoverable data
destruction “hard” reset) to the internet gateway, disconnect
power to the internet gateway and while powered off, use a thin
tool, such as paper clip or a toothpick, to press and hold pressed
the internet gateway's reset button. While continuing to hold the
reset button pressed, connect power to the internet gateway.
Continue to hold the reset button pressed for 10 – 20 seconds
until the gateway's Yellow light blinks, then immediately release
the reset button.