Wear protective goggles when working overhead to protect your eyes from injury.
Disengage all existing garage door locks to avoid damage to the garage door.
To avoid serious personal injury from entanglement, remove all ropes connected to the garage door before
installing the opener.
Note: It is recommended that the opener be installed no less than 2.1m above the floor where space permits.
3
1
2
4
Header Bracket Positioning
The header bracket must be rigidly fastened to a
structural support of the garage. Reinforce the
wall or ceiling with a 40 mm (1-1/2") board if
necessary. Failure to comply may result in
improper operation of safety reverse system.
You can attach the header bracket either to the
header wall (1) or to the ceiling (3). Follow the
instructions which will work best for your particular
requirements.
With the door closed, mark the vertical centerline (2)
of the garage door. Extend line onto header wall
above the door.
Open door to highest point of travel. Draw an
intersecting horizontal line (4) on header wall 5 cm
(2") above high point to provide travel clearance for
top edge of door.
12
7
3
1
4
2
6
3
2
8
5
4
3
2
6
1
Install Header Sleeve and Tighten Belt
Slide header sleeve (1) onto rail (5). Slide flat washer (3), spring (2) and washer (3) onto carriage bolt (4). Thread nut (6)
onto carriage bolt until finger tight. Use an open end wrench (7) to tighten nut until the belt is approximately 2mm above
the base of the rail at its midpoint.
DO NOT OVER TIGHTEN THE BELT
. See image (8
).
11
INSTALLATION SECTION
