Chamberlain Merlin MT60, Иллюстрированное руководство пользователя

Страница: 13 / 22

1
3
2
m meerrlliinn
++
4
6
5
7
LOCK
LIGHT
LOCK
LIGHT
m meerrlliinn
++
22
Program your Opener & Remote
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter
or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not
allow children to play near the door.
Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional
remote controls, the garage door opener must be programmed to accept the new remote code.
Program the Receiver to Match Additional Remote Control Codes:
Using the orange “LEARN” Button
1. Press and release the orange “learn” button on the opener. The learn indicator light will glow steadily for 30 seconds
(1).
2. Within 30 seconds, press and hold the button on the hand-held remote that you wish to operate your garage door (2).
3. Release the button when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will
be heard (3).
Using the Multi-Function Door Control:
4. Press and hold the button on the hand-held remote that you wish to operate your garage door (4).
5. While holding the remote button, press and hold the LIGHT button on the Multi-Function Door Control (5).
6. Continue holding both buttons while you press the push bar on the Multi-Function Door Control (all three buttons are
held) (6).
7. Release buttons when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will be
heard (7).
Now the opener will operate when the remote control push button is pressed. If you release the remote control push
button before the opener light flashes, the opener has not learned the code.
To Erase all Remote Control Codes
To deactivate any unwanted remote, first erase all codes: Press and hold the orange “learn” button on opener until the
learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or
keyless entry you wish to use.
3-Channel Remote:
If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any
rolling code 3-channel remote or mini-remote can be programmed to operate this or other rolling code garage door
openers.
13