Chamberlain Merlin MT5580 Скачать руководство пользователя страница 17

Страница: 17 / 20

CARE OF YOUR OPENER

When properly installed, opener will provide high performance with a minimum of maintenance. The opener does not require additional lubrication.

Limit and Force Adjustments:

These adjustments must be checked and properly set when opener is installed. Only a screwdriver is

required.

Weather conditions may cause some minor changes in the door operation, requiring some re-adjustments, particularly during the first year

of operation.

Refer to the limit and force adjustments on page 13. Follow the instructions carefully and

repeat the safety reverse test after any adjustment.

Remote Control Transmitter:

The portable remote control may be secured to a car sun visor with the clip provided. Additional remotes can be

purchased at any time for use in all vehicles using garage. Refer to Accessories. Any new remotes must be set to the same code as the original
remote.

Remote Control Battery:

The lithium batteries should produce power for up to 5 years. When the light becomes dim or does not come on, replace

the battery. If transmission range lessens, check the battery test light.

To Change Battery:

To replace batteries, use the visor clip or screwdriver blade to pry open the case. Insert batteries

positive side up.

To replace

cover, snap shut along both sides. Do not dispose of the old battery with household waste. Take batteries to a proper disposal center.

MAINTENANCE OF YOUR OPENER

Once a Month:

•

Repeat safety reverse test.

Make any necessary adjustments.

•

Manually operate door.

If it is unbalanced or binding, call for professional garage door service.

•

Check to be sure door opens and closes fully.

Adjust Limits and/or Force if necessary.

Once a Year:

Oil door rollers, bearings and hinges.

The opener does not require additional lubrication. Do not grease the door tracks.

HAVING A PROBLEM?

1. Opener doesn't operate from either door control or remote:

• Does the opener have electric power? Plug lamp into outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled

by a wall switch.)

• Have you disengaged all door locks? Review installation instruction warnings on page 1.

• Is there a build-up of ice or snow under door? The door may be frozen to ground. Remove any obstruction.

• The garage door spring may be broken. Have it replaced.

• Repeated operation may have tripped the overload protector in the motor. Wait 15 minutes. Try again.

2. Opener operates from remote but not from door control:

• Is door control button lit? If not, remove the bell wire from the opener terminals. Short the red and white terminals by touching both terminals at the

same time with a piece of wire. If the opener runs, check for a faulty wire connection at the door control, a short under the staples, or a broken wire.

• Are wiring connections correct? Review page 10.

3. Door operates from door control but not from remote:

• Check battery. Replace battery if necessary.

• Is the light at the wall control flashing? Press button with key-symbol to unlock the opener against remote controls.

• Is the receiver LED flashing at the back-side of the opener when the transmitter is pressed? The opener receiver must re-learn the remote control

code. Follow the instructions on page 4.

• If you purchased a new remote control then check at carton of remote control for compatibility or call the Service Hotline.

4. Remote has short range:

• Is battery installed? If needed, change the battery.

• Change the location of the remote control on the car.

• A metal garage door, foil-backed insulation or metal siding will reduce the transmission range.

• Use outside coaxial antenna adapter to move antenna.