background image

MOUNTING STAND

MSLM

The mounting stand is deal to raise slide operator higher above the ground for snow and other 
applications. The mounting stand can be used with post and concrete pad applications. This kit 
is a direct replacement for Robo and some other manufacturer’s stands.
Check the national and local building codes before installation.

INSTALLATION

The gate operator should be installed near the front roller of the gate or near the back of 
the gate (in the OPEN position). The space between the gate and the output sprocket must 
be a minimum of 4 inches.

4"(10 cm) 

24"

(61 cm)

STANDARD INSTALLATION

REAR INSTALLATION

1

1

1

4"(10 cm) 

24"
(61 cm)

24" (61 cm)

24"
(61 cm)

To reduce the risk of SEVERE INJURY or DEATH: 
•    Disconnect ALL electric and battery power BEFORE performing ANY service 

or maintenance. 

•     Without a properly installed safety reversal system, persons (particularly small children) 

could be SERIOUSLY INJURED or KILLED by a closing gate.

•     Too much force on gate will interfere with proper operation of safety

reversal system.

•     NEVER increase force beyond minimum amount required to close gate.
•     NEVER use force adjustments to compensate for a binding or sticking gate.
•     If one control (force or travel limits) is adjusted, the other control may also need 

adjustment.

•     After ANY adjustments are made, the safety reversal system MUST be tested. Gate MUST 

reverse on contact with a rigid object.

•    READ AND FOLLOW ALL INSTRUCTIONS.
•     ANY maintenance to the operator or in the area near the operator MUST NOT be 

performed until disconnecting the electrical power and locking-out the power via the 
operator power switch. Upon completion of maintenance the area MUST be cleared and 
secured, at that time the unit may be returned to service.

•    Disconnect power at the fuse box BEFORE proceeding. Operator MUST be properly  

 

grounded and connected in accordance with local electrical codes. 

NOTE:

 The operator should be on a separate fused line of adequate capacity.

•    NEVER let children operate or play with gate controls. Keep the remote control away 

from children.

•     ALWAYS keep people and objects away from the gate. NO ONE SHOULD CROSS THE 

PATH OF THE MOVING GATE.

•    Test the gate operator monthly. The gate MUST reverse on contact with a rigid object or  

stop when an object activates the non-contact sensors. After adjusting the force or the   
limit of travel, retest the gate operator. Failure to adjust and retest the gate operator    
properly can increase the risk of INJURY or DEATH.

•     Activate gate ONLY when it can be seen clearly, is properly adjusted and there  

 

are no obstructions to gate travel.

Отзывы: