Chamberlain Icon26 series, Руководство пользователя

Страница: 18 / 44

POSTAL LOCK INSTALLATION
17
Icon Page
(+)
(-)
GND
(+)
(-)
GND
(+)
(-)
GND
IN GND
V-C V-NO
(+)
(-)
GND
COM NC NO TIP RING
2-NO 2-NC 2-COM 1-NO 1-NC 1-COM GND 2-IN 1-IN
COM NC NO
RS-485 (4)
RS-485 (3)
AUX
OUTPUT RELAYS
AUX
INPUT
12V
AC/DC
RS-485 (2)
POWER IN
TEL LINE IN
POSTAL
SWITCH
EXIT
INPUT
VCR
RELAY
/
RS-485 (1)
GATE
RELAY
DOOR
RELAY
CHASSIS
GROUND
CAMERA
VIDEO
OUT
It is MANDATORY that this unit is properly
grounded. The provided "chassis ground"
wire must be connected to the ground rod.
If unit is not grounded, lightning damage
Installation:
These parts are used only when postal access to your facility is required. The postal lock mechanism must be obtained by application
to your local post office.
Open the front panel of the Telephone Entry System and remove the hole plug.
(Retain nuts and washers) Install the postal lock with the sliding bolt oriented
away from the speaker.
Install the enclosed plate end switch assembly over the sliding bolt so that
when the bolt is extended it will activate the switch as shown in the diagram.
Fasten by using the enclosed flat washer, lock washer, and nut on each of the
four studs. Adjust the plate and switch location as the nuts are tightened to
ensure switch activation when the bolt is extended.
Connect the two wires from the postal lock switch to the postal/exit connector
on the surge suppressor terminal board. Note that polarity or color coding is
not required. When the postal lock is engaged, the system’s gate relay is
activated for a duration according to the programmed
“Gate Strike Time” .
Test operation by activating the lock. Ensure that full extension of the sliding
bolt will not bend or break the switch.
AN
BRD
L GHT
AU
RE
AUX 2
R LAY
GA E
R LAY
OR
RE AY
1
2
3
4
5
6
Postal Lock
Switch Assembly
Stainless Steel
Front Panel of
Entry Phone
Switch Assembly
Mounting Holes
(Mount with Postal
Lock on Entry Phone
Front Panel)
Postal Lock
Side View
Postal Lock
Switch Wires (2)
Postal Lock
Switch Assembly
Front View
Switch Assembly
Mounting Holes