BACK BOX AND TRIM KIT
MODEL CAPXLTK
INTRODUCTION
The CAPXLTK back box and trim kit allows you to fl ush mount an CAPXL
unit into a cutout of a wall (or other fl at surface). The CAPXLTK is used for
new installations or retrofi ts ELITE Icon26 and Sentex Infi nity L systems.
INSTALLATION
1. Cut a hole in the wall to accommodate the back box of the trim kit
(back box dimensions: 18-1/2" x 14-13/16" [47 cm x 37.6 cm]).
2. Separate the trim plate from the back box by carefully pulling the trim
plate away from the back box.
3. Place the back box into the cutout. Use metal shims or hold the box
level while marking the mounting holes through the side brackets.
4. Fasten the back box and side bracket assembly to the wall or mounting
surface.
5. Snap the trim plate onto the back box ensuring the slots in the trim
plate are fully engaged with the screw heads.
6. Remove the four mounting knockouts found on the rear face of the
CAPXL back box.
7. Install the CAPXL using Phillips head screws 6-32 x .25" (4) and
#8 lock washers (4)(not provided).
Carton Inventory:
Back box assembly, trim plate, instructions.
Additional Items You May Need:
Phillips head screws 6-32 x .25" (4) and
#8 lock washers (4).
Trim Plate
Side
Bracket
Side
Bracket
Back Box
19-7/16"
(49.4 cm)
23-49/64" (60.4 cm)
18-1/2" (47 cm)
14-13/16" (37.6 cm)
3-3/10"
(8.4 cm)
WARNING:
This product can expose you to chemicals includ-
ing lead, which are known to the State of California to cause
cancer or birth defects or other reproductive harm. For more
information go to
www.P65Warnings.ca.gov