Chamberlain ATS, Руководство пользователя, Страница: 29 / 72

29
1. Press and release the “learn”
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote.
3. Release the button when the
motor unit light blinks. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
PROGRAMMING
NOTICE: If this Security
✚ ®
garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Security
✚ ®
3-Button Remote Control Programming (Optional)
Instructions are Described and Illustrated Below
The 300 Series remote control works only with door
openers and light controls having a purple “Learn” button.
Programming instructions are described and illustrated
below. The additional push buttons can also activate other
garage door openers and/or light controls. (Instructions
for programming light products are included with those
accessories.)
To Control the Opener Lights
With Security ✚ ®
remote controls, a remote push button
can be programmed to operate the opener lights without
opening the door.
1. With the door closed, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights fl ash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all codes:
Press and the hold “learn” button on motor unit until the
learn indicator light goes out (approximately 6 seconds).
All previous codes are now erased. Reprogram each
remote or keyless entry you wish to use.
Open/Close/Stop Operation
Your Security
✚ ®
remote control
can be programmed to operate one
door using all 3 buttons: the large
button will only open the door, the middle button will close
the door and third button will stop the door’s movement.
You may set up this feature as follows:
1. With the door closed, press and hold the large remote
push button.
2. Press and hold the Lock button on the door control.
3. Press and hold the door control push bar.
When the opener lights fl ash, release all buttons. Test by
pressing the large (Open) button on the remote. The door
should open. Press it again while the door is open and
nothing should happen. Press the middle (Close ) button
and the door should close. Press the third (Stop) button
while the door is moving and it should stop immediately.
To prevent possible SERIOUS INJURY or DEATH from
a moving gate or garage door:
• ALWAYS keep remote controls out of reach of
children. NEVER permit children to operate, or play
with remote control transmitters.
• Activate gate or door ONLY when it can be seen
clearly, is properly adjusted, and there are no
obstructions to door travel.
• ALWAYS keep gate or garage door in sight until
completely closed. NEVER permit anyone to cross
path of moving gate or door.
Open
Close
Stop