-2-
KEY PAD
If you make a mistake when entering the PIN, press “
•
“, the last digit entered will be deleted.
Each time a button is pressed, a beep will be heard. This is a safety feature so that you will know when
•
the safe is being accessed and cannot be switched off.
If you Press “
•
”, “
bELL on” will be displayed. This will display the battery power status.
However, there is no function to switch the bELL (beep) off.
PROGRAMMING YOUR PIN NUMBER
(
personal identification number
)
DEFAULT FACTORY USER PIN: 1234 : DEFAULT FACTORY MASTER PIN: 123456
Either of these PIN Codes can be set from 1 to 8 digits.
WE STRONGLY RECOMMEND THAT 4 OR MORE NUMBERS ARE USED AS THE USER CODE AND
6 OR MORE FOR THE MASTER CODE.
Keep PIN codes in a safe place. Do not use personal information like birthdays, telephone numbers etc.
NOTE:
The following steps will only change one PIN, either the User or Master PIN based on the PIN
you entered in step 2.
In order to change the other PIN, simply repeat steps above, using the other code at step 2.
Write down your PIN codes so you do not forget it. (any combination of numbers from 4 to 8 digits)
Press “#”
1.
Enter the either the User PIN or the Master
2.
PIN
Press “#”
3.
The safe will beep 3 times and display
4.
“OPEN”.
Press “
5.
” within 10 seconds.
The LCD will display “--------”.
6.
Enter your New User or Master PIN
7.
Press”#”
8.
The LCD will display”--------”
9.
Re-enter your New User or Master PIN.
10.
Press “#”
11.
The LCD will display “Into” for a few seconds
12.
Your new PIN has been set.
13.
While the door is open familiarise yourself with the door opening procedure, and leave the door open
until you are satisfied that you fully understand the opening and closing method. You can re-set the PIN
at any time by following the above procedure.
RESETTING THE PIN CODE TO THE FACTORY DEFAULTS
PIN CODES
(
personal identification number
)
The safe can be reset back to the factory default PIN codes by
pressing the red button situated on the inside cover of the safe
door (Dia 2).
Open the safe door. Remove the reset button’s security cap by
unscrewing it.
Press the red reset button. The display will show “CLEAr”; all PIN
codes will revert back to the factory default PIN codes.
Please refit reset button’s security cap for security reasons.
OPENING THE DOOR USING YOUR PIN NUMBER
(
personal identification number
)
Press ”#”
•
Enter your PIN (either your user or master PIN code)
•
Press “#”
•
The safe will beep 3 times and display “OPEN”.
•
Turn the locking knob clockwise within 10 seconds and pull the safe door open.
•
If the PIN code is entered incorrectly the LCD will display “Error”. Wait for the display to clear and try
•
again.
If the voltage of batteries is low the LCD will show “Lo-bAtt”. The batteries must be replaced.
Dia.2
Security cap
covering reset
button
