8
The switch can take place with the machine running:
Pendulum Setting:
Step
Pendulum action
Material
0
No
rubber, ceramic, aluminum, steel
1
Small
plastic, wood, aluminum
2
Large
wood
TROUBLESHOOTING
If your Jigsaw will not operate, check the fuse and the power at the mains plug.
If the Jigsaw is not cutting properly check the blade and support roller, replace
blade if worn. Also check the cutting angle, the blade must be at exactly
90º(degrees) to the base for normal use. There are no user serviceable parts in
the Jigsaw. If a fault cannot be found return the Jigsaw to an authorized dealer
for repair.
MAINTENANCE
1. Store the tool, instruction manual and accessories in a secure place. In this
way you will always have all the information and parts ready to hand.
2. Keep the tool’s air vents and the dust extraction holes in the base free of
dust and dirt.
3. Remove dust and dirt regularly. Cleaning is best done with compressed air
or a rag.
4. Lubricate all moving parts at regular intervals.
5. Never use caustic agents to clean plastic parts. Wipe clean with a dry cloth.
6. When the brushes are worn, the tool will stop.
7. Have new brushes fitted by an authorized service facility.
CAUTION:
Do not use cleaning agents to clean the plastic parts of the tool. A mild
detergent on a damp cloth is recommended. Water must never come into
contact with the tool.
9
PLUG FITTING
This Jigsaw is supplied with a fitted plug; however if you should need to fit a
new plug follow the instruction below.
IIMPORTANT
The wires in the mains lead are
colored in accordance with the
following code:
Blue = Neutral
Brown = Live
As the colours of the wires in the
mains lead of this appliance may
not correspond with coloured
markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is
marked with
N
or coloured black. The wire which is coloured brown must be
connected to the terminal which is marked with the letter
L
or coloured red.
No connection is to be made to the earth terminal of the plug.
If a
13 AMP
(BS1363/A) Plug is used, a
13 AMP
Fuse must be fitted, of if any
other type of plug is used a 13Amp Fuse must be fitted, either in the Plug or
Adaptor, or on the Distribution Board.
NOTE:
If moulded plug is fitted and has to be removed take great care in
disposing of the plug and severed cable, it must be destroyed to prevent
re-use, or connection to any electrical supply.
If the supply cord is damaged it must be replaced by a service agent or a
similarly qualified person in order to avoid hazard.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools and
packaging should be sorted, taken to the local recycling center and disposed of
in an environmentally safe way.
