APR 2018
CMT-330TC Three-Knife Trimmer
2-18
2. Installation Guide
Figure 2-42. Start Button
13. The machine was shipped with the cutting
mechanism in the down position. If power is
hooked up correctly, the mechanism will au-
tomatically rise up to the up position when
the start button is pressed. If power is incor-
rectly connected, the mechanism will remain
in the down position.
If power was correctly connected, skip steps 14-
18 and go to Section 2.8 Main Air Hookup.
14. Switch off (
O
) the machine's main power
switch.
15. Switch off (
O
) the main power disconnect
switch and lock it out.
16. Remove the power panel door at the right-
hand side of the machine.
17. Exchange any two of the main power leads
at the terminals
L1
,
L2
, or
L3
.
Содержание CMT-330TC
