APR 2018
CMT-330TC Three-Knife Trimmer
2-8
2. Installation Guide
2.4.3 Pile Feeder (Stand Alone)
Figure 2-19. Pile Feeder
Setup Procedure
1. Setup the book pile feeder according to the
instruction and parts manual supplied with
the book pile feeder.
2. Move the trimmer into position against the
pile feeder, aligning the mounting brackets
on the pile feeder to the corresponding holes
in the side of the trimmer. Once the trimmer
height is set properly according to Section
2.5 Trimmer Height Setup, attach the pile
feeder to the trimmer using supplied mount-
ing hardware.
Cable and Air Tubing Connections
1. Remove the lower front panel of the trimmer
and locate the yellow power cable coiled up
inside the trimmer that is labelled with the
number that corresponds to the label on the
pile feeder near the input connectors. The
power cables are the larger diameter cables
with 7-pin connectors on the end.
2. Route the power cable under the hydraulic
unit and out of the left side of the trimmer.
3. Connect the power cable as shown in Figure
Figure 2-20. Power Cable Connection
4. Now locate the yellow communication cable
coiled up inside the trimmer that is labelled
with the number that corresponds to the la-
bel on the pile feeder near the input con-
nectors. It is a small diameter cable with a
3-pin connector on the end. Also locate any
separate communication cables that were
supplied with the infeed/outfeed options.
5. Connect the communication cables as
shown in Figure 2-21.
Figure 2-21. Comm. Cable Connections
6. Now locate the coiled-up line of blue air tub-
ing with a red and white connector on the
end that is labelled with the number that cor-
responds to the label on the pile feeder near
the input connectors.
7. Connect the air tubing as shown in Figure
Содержание CMT-330TC
