Challenge CMT-130, Руководство по обслуживанию

Страница: 86 / 226

FEB 2017
4. Repair/Adjustment Procedures 4-2 CMT 130 Book Trimmer
REP 4.1 Cut Stick Replacement
The cut stick (PL 5.3 Main Assembly 59000
(3/12)) should be changed or rotated with every
knife change. They may require changing more
often than that if deep grooves or jagged edges
can be seen along the score marks. A worn cut
stick wear can affect cut quality.
The cut stick can be rotated 8 times before dis-
posal. It is located in the table beneath the
knife, accessed through the door at the rear of
the machine.
WARNING
Disconnect and lockout power as described
in the Power Lockout Procedure on page viii.
Initial Actions
Locate the Cut Stick Puller provided with the
machine. It is located on the inside of the rear
door. The cut stick puller has a finger hold and
hook (Figure 4-1).
Procedure
1. Switch off power, remove the waste bin, and
open the back door.
2. Hook the Cut Stick Puller over the right end
of the cut stick (Figure 4-2) with a finger in
the loop of the puller. Keep the Cut Stick
Puller in-line with the cut stick.
3. Pull the Cut Stick Puller at a slight angle
(Figure 4-2) over the cut stick until the end
of the cut stick comes out of the table.
4. Remove the remaining cut stick from the ta-
ble by hand.
5. Inspect the cut stick for wear. It may be
used 8 times (twice on each surface) before
disposal. To use a surface twice, reinstall
the cut stick by turning it such that end that
came out of the right end of the slot goes
into the left end of the slot. If a surface has
been used twice, rotate the stick to an un-
used surface before reinstalling (Figure 4-3).
If all (4) surfaces have been used twice, re-
place the stick with a new one (PL 5.3 Main
Assembly 59000 (3/12)).
6. Securely close the door and replace the
waste bin.
Figure 4-1. Cut Stick Puller
Figure 4-2. Pulling Cut Stick Up
Figure 4-3. Cut Stick Rotation