Challenge 1500W High Pressure Washer, Инструкция по эксплуатации

Страница: 5 / 10

fig. 5
fig. 7
fig. 6
fig. 8
OPERATING INSTRUCTION OPERATING INSTRUCTION
When using your Pressure
Washer, the recommended
working distance between
the nozzle and the object or
surface to be cleaned is 30cm.
Instructions for Use
1. Fully open the water mains tap -
Do not at this point switch on
your pressure washer.
2. Never operate your pressure
washer without the water supply
switched on.
3. Hold the Trigger Switch G until all
the air has been expelled from the
Pressure Washer and the water
starts to flow. As soon as the water
starts flowing out of the nozzle,
release the trigger. You have now
primed your Pressure Washer with
water.
4. The Pressure Washer can now be
switched on.
Switching On and Off
1. Ensure that the mains switch is in
the "On" position.
2. To switch the Pressure Washer on,
set the On/Off Switch A to "On".
3. To switch the Pressure Washer off,
set the On/Off Switch A to "Off".
See fig. 5.
Operating your Pressure Washer
1. Your spray lance has two main
settings. These settings can be
varied by turning the fitting on the
end of Spray Lance Extension K
fitted to the end of the Spray Lance
Socket J .
2. Turn the Fitting clockwise for a
pointed jet (marked STREAM) or
turn the nozzle anti-clockwise for
a flat jet (marked FAN).
See fig. 6 and 7.
3. Always ensure that the trigger is
closed and the Pressure Washer
is switched off before changing the
nozzle settings.
9 8
Turn the unit off between
use. It should not be left on
and unused for more than 5
minutes. If left longer than this
time the water in the system will
heat up and could cause severe
damage to the pump.
A
K
K
F
J
4. Aim the lance towards the object
to be cleaned - working within the
recommended distance. Squeeze
the lance trigger until the water
starts flowing, then switch on the
Pressure Washer by activating the
On/Off Switch A .
Front view of the Nozzle Spray Effect
Pointed Jet
Flat Jet