4). If any grass residues are caught in
the discharge chute, clean it using a
brush.
5). Do not remove grass debris in the
mower casing or on the blade by hand
or with your feet. Instead use suitable
tools such as a brush or broom.
6). To ensure that the cut grass can be
collected into grass collection bag,
the discharge opening and inside the
mower casing must be cleared of any
blockage.
Always empty the grass bag when you
have
fi
nished the mowing, even if it is
not full. Stored grass residue is a
fi
re
hazard.
11. Replacing the blade
(See Fig. G)
Maintain the sharpness of the blade
when cutting grass. If the blade has
worn excessively and become pitted
and blunt, it should be replaced or
sharpened. The sharpness of the blade
will affect the performance of the
lawnmower.
For safety reasons we recommend
that the blade is only changed by
persons quali
fi
ed and authorized to do
so.
WARNING!
before replacing the
blade, ensure that the engine is
switched off and the spark plug cap is
disconnected and moved away from the
spark plug.
3)Fit a new blade or re-sharpen the
blade, locate the blade on the two studs
on the blade
fl
ange and then replace the
washer and bolt. Make sure the blade
is correctly located, then
fi
rmly tighten
the bolt. Do not over tighten.
The up turn of the blade must project
into the motor compartment.
Always handle the blade with care-sharp
edges could cause injury USE GLOVES.
Renew your metal blade after 50Hrs
mowing or 2yrs which ever is sooner
regardless of condition.
If the blade is cracked or damaged
replace it with a new one.
MAINTENANCE
1. Cleaning
To ensure the best performance of
your lawnmower, it is important
to keep it clean. Always clean your
lawnmower immediately after use.
Do not allow grass cuttings and other
debris to become dry and hard on any
of the mower surfaces. This will directly
affect the cutting and grass collection
performance. Make sure that the
underside of the lawnmower deck is
clean and clear.
Ensure the discharge chute and grass
discharge
fl
ap are clean. The grass bag
must always be emptied after use. Make
11
2)Hold the blade and unscrew the blade
bolt counterclockwise using a spanner
wrench. Remove the washer and the
blade.
sure that the exterior of the engine is
clear of all debris, cuttings and dirt.
Maintenance schedule
12 hours of
use
24hours
of use
36hours
of use
Air
fi
lter
clean
clean
replace
Spark plug
check
clean
replace
Engine oil
check
replace
check
2). To maintain safety, the discharge
fl
ap will close back to cover the rear
discharge chute, when you release the
fl
ap.
3). Empty the grass debris in the grass
collection bag, and re
fi
t grass collection
bag.
1)You will need garden gloves (not
provided) and a spanner wrench to
remove the blade.
ORIGINAL INSTRUCTIONS
HELPLINE NO 08454505299
Never turn over the lawnmower.
