HELPLINE NO 08454 505299
12
ORIGINAL INSTRUCTIONS
SAWING
Use undamaged faultless saw
blades only.
Deformed, blunt saw blades or saw blades
that are otherwise damaged can break.
When sawing light building
materials, observe the statutory
provisions and the recommendations
of the material suppliers.
Plunge cuts may only be applied to
soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with HCS saw blades in wood,
particle board, building materials, etc., check
these for foreign objects such as nails, screws,
or similar. If required, remove foreign objects
or use 50CrV or higher quality saw blades.
Work with low and uniform
application pressure, otherwise, the
application tool can become blocked
or cause resonance.
OPERATION
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch
located on the topside of the motor housing
Switching on:
TO TURN THE TOOL "ON" slide the switch
button forward to the “I” .
Switching off:
TO TURN THE TOOL "OFF" slide the switch
button backward the “0” .
WARNING! Hold the tool with both hands
while starting the tool, since torque from the
motor can cause the tool to twist.
SANDING
1. Sanding accessories are suitable for dry
sanding of wood, metal, smaller surfaces
corners and edges and hard to reach
areas.
2. Profiles and grooves may be finished
using the tip or edge of the selected
accessory, which should occasionally be
rotated during use to distribute the wear
on the accessory and backing pad surface.
3. Always be certain that smaller workpieces
are securely fastened to a bench or other
support.
Larger panels may be held in place by
hand on a bench or sawhorses.
4 With the workpiece firmly secured, turn
tool on as described above.
5. Move the tool in long steady strokes
parallelto the grain using some lateral
motion to overlap the strokes by as much
as 75%.
DO NOT apply excessive
pressure - let the tool do the work.
Excessive pressure will result in poor
handling, vibration, and unwanted
sanding marks
MAINTENANCE
1) Always keep the device clean, dry and
free of oil or grease.
2) Clean the device immediately after you
have finished using it
3) Do not allow any liquids to enter the
device. Use a cloth to clean the housing.
4) Never use petrol, solvents or cleaning
agents that might attack plastic.
Tips for maintaining maximum battery life
1) Charge the battery pack before it is
completely discharged. Always stop tool
operation and charge the battery pack
when you notice a decrease in tool power.
2) Never recharge a fully charged battery
pack. Overcharging shortens the battery
service life.
3) Charge the battery pack with room
temperature at 10°C-40°C and let a hot
battery pack cool down before charging it.
4) Charge the Lithium-ion battery pack when
you do not use it for more than six months.
Always pull the battery charger out of the
mains socket and remove the battery pack
before you clean or maintain the device.
The cordless multi-purpose tool is
maintenance-free.
