HELPLINE NO 08454 505299
8
ORIGINAL INSTRUCTIONS
2. SETT ING OF TOOL REST AND
SPARK ARRESTER BRACKET
(See Fig. C, D)
The tool rest and spark protection
assembly’s spark arrester bracket have to
be set from time to time to compensate for
grinding wheel wear. The gap between tool
rest and wheel should not be more than
2mm and not more than 2mm between
wheel and spark arrester bracket.
3. COMMISSIONING
This double bench grinder is used for rough
grinding. Please note that it is not intended
for continuous operation. To prevent
possible overloading/overheating it should
not be operated for more than 15 - 30
minutes at a time. Let grinder cool down
before operating again.
Apply moderate pressure when holding
the workpiece against the grinding wheel.
Remember that the metal heats up by the
grinding. The workpiece should therefore
regularly cooled by submerging it in cold
water. The dry grinding wheels of this bench
grinder are suitable for rough grinding only.
Before using the tool, read the
instruction book carefully.
OPERATING INSTRUCTIONS
For reasons of packing the spark protection
assembly is not factory installed and needs
to be user installed before operation of the
machine. Fig. A shows the components of
the spark protection assembly and how they
are installed to the grinding wheel cover on
the right hand side.
Installation to the left hand side wheel cover
is similar.
1. INSTALLATION OF SPARK
PROTECTION ASSEMBLY
(See Fig. A, B)
Fig. A
Fig. B
a: head screw
b: hexagon nut
c: lock washer
d: head bolt
Fig. C
Fig. D
