12
Front Panel
Connector
Set (CN5) A through G
A. Over-ride Power Button
Connector
The power button on the ATX chassis can be used as a
normal power switch as well as a button to activate
Advanced Power Management Suspend mode. This
mode is used for saving electricity when the computer is
not in use for long periods of time. The Soft-OFF by
PWRBTN function in BIOS's Power Management Setup
must set to "Delay 4 Sec." to activate this function.
When the Soft-off by PWRBTN function is enabled, pushing
the power button rapidly will switch the system between
Full-On and Suspend mode. Pushing the button rapidly
again or any occurence of external activity such as pressing
a key on the keyboard will bring the system back to Full-On.
Pushing the button while in Full-On for more than 4 seconds
will switch the system to Soft-off and pushing the button
again rapidly will turn the system back to Full-on. See Over-
ride Power Button Operation diagram.
B. Keyboard Lock & Power Indicator LED
Connector
Plugging this connector into the lock on the front panel
of the system case allows the lock to enable or disable
the keyboard. This function provides limited security
against casual intruders. The power indicator LED shows
the system's power status and willl flash when the system
is in Green mode (Suspend).
C. Green Switch/Green LED Connector
Over-ride Power
Button Operation
Pin
Definition
1
+5V DC
2
Not Connected
3
Ground
4
Keylock
5
Ground
Keyboard Lock
Power indicator LED
1
+
1
1
1
+
+
1
1
5agm3-2.p65
2000/4/11, PM 05:50
12
