CHAD-O-CHEF OFP 400, Инструкция по эксплуатации

Страница: 8 / 12

5
CHECkLIST FOR GAS INSTALLER
CAUTION
Before calling the manufacturer, ensure that all the checkpoints below
conform. Refer to the latest SANS 1539:2017 Annex A ,C & E
Check there is gas in the gas bottle (if bottle is nearing empty change over to
new bottle)
Check that the inlet working pressure is 2.8 kPa. If not correct:
Check that the supply pipe is the correct diameter for the distance
covered.
Check that the regulator is functioning correctly, and not “humming”.
The burner must be correctly positioned and sitting flush on the bottom
plate.
Check that the gas jet is centrally aligned with the burner venturi.
Check for spider webs in the venturi.
The black ceramic ash supplied with the Chad-O-Chef firepit must be
placed inside the burner.
Ensure that the number of Gas Logs placed on the firepit is correct, as
supplied by Chad-O-Chef.
DO NOT use more Ceramic Ash or Gas Logs than recommended and
supplied. (See Page 3)
Ensure that there is adequate ventilation for the Firepit (See Page 2)
Do not tamper with jets, burners or regulator settings. NEVER MODIFY OR
ADAPT CHAD-O-CHEF PRODUCTS TO WORK DIFFERENTLY.
CHAD-O-CHEF products are preset and tested to function efficiently and are
approved by the LPGSA.
Should a burn back occur, i.e. the jet catching alight at the entry to the burner
with a noticeable loud rushing sound: Turn the gas off immediately and
relight after 1 min. If condition persists, contact your gas installer.
Should a leak in the gas be detected, turn off the gas at the gas cylinder, and
contact your installer immediately.
Should there be an unexplained shutdown, which could be the result of
insufficient oxygen in the burner, shut off the gas supply, then wait 3-5 min
before attempting to restart. If condition persists, contact your gas installer.