EN – Wireless wall switch & Module
(54501, 54511, 54502, 54512, 54505)
Install the module (receiver) :
1° Disconnect main power before installation.
2° Dismantle screw tab holder for wall box insertion. Connect AC wire and load
(lamp) to receiver block terminal.
3° Connect main power on., LED indicator on receiver should light on.
4° Link the module to transmittor (see Programm).
Install the wall switch:
to the wall.
Dimmer Function :
Push On button twice, light begins to dim. Push once again,
light stops at chosen intensity. To dim again, restart the process.
* WORKS ONLY WITH DIMMER MODULE (300W/54556).
Link Code :
1° Bring the transmitter near the receiver, push the module learning button once.
2° Module led will blink slowly, push the wall switchON button.
3° Module connected lamp will blink twice, code is confirmed and led stops
blinking.
Delete a code :
1° Push the learning button on module once, led blinks slowly.
3° Push the transmitter OFF button of the wall switch.
4° Receiver connected lamp will blink twice, code is deleted and led stops
blinking. Repeat Link steps for re-setting.
Delete all memories :
1° Push the learning button on module for 6 seconds, led blinks.
2° Release and push again once.
3° Receiver connected lamp will blink twice, memory is erased and led stops
blinking.
* ALL PROGRAMMED MEMORY WILL BE DELETED.
Receiver has 6 memory settings :
Self program function receiver has 6 memory settings. It can be programmed as
Example : if there is 3 receivers (1. lamp shade, 2. night light, 3. fan). Receiver 1,2,3
can be control individually with transmitter button 1,2,3. Receiver 1,3 can be
programmed with transmitter button 4, (lamp shade and fan ON/OFF at same
time). Receiver 1,2,3 can also be programmed into group function ALL ON or OFF
at same time into group button (lamp shade, night light and fan ON/OFF at same
time)
Fault finding:
No activation : Check battery polarity or running out battery. Check code
program sucessful. Check the module fuse.
Caution:
Do not place two receivers near each other, the distance should be above 1
meter. Transmission distance is about 50m, but it can be reduced depending on
wall thickness or wireless environment.
Warning! Do not use in samp places. Disconnect main power before wiring
installation and fuse changing. DO NOT OVERLOAD.
Hereby CHACON declares that the device is in conformity with the essential requirements
e RED 2014/53/EU:
v
it
c
e
ri
d
e
h
t
f
o
s
l
a
s
o
p
s
i
d
t
n
a
v
e
l
e
r
r
e
h
t
o
e
h
t
d
n
a
www.chacon.be - Support - Downloads (54505)
IMPOR
rective 2002/96/EC WEEE) :
During the sorting of your waste, we ask you to respect the
r
egulations in e ect regarding their elimination.
We thank you for depositing them in a place allowed to
this purpose and respecting the environment.
