Install of The Compact Panel Cassette Type Indoor Unit
2
2 Install of The Compact Panel Cassette Type Indoor Unit
2.1 Schematic diagram of installation spaces
≥
98 (
2500
)
≥5
9(
1500
)
≥5
9(
1500
)
Model
H
10 (
260
)
unit:
in (
mm
)
＞
0.
75(
20
)
Wall
surface
Wall
surface
Wall
surface
Ground
surface
H
GKH(12)BA-D3DNA2A/I
GKH(18)BA-D3DNA2A/I
Fig.1
2.2 Select install location of the indoor unit
(1).
Obstruct should put away from the intake or outlet vent of the indoor unit so that the airflow
can be blown though all the room.
(2). Make sure that the installation had accord with the requirement of the schematic diagram of
installation spaces.
(3). Select the place where can stand 4 times of the weight of the indoor unit and would not
increase the operating noise and oscillate.
(4). The horizontally of the installation place should be guaranteed.
(5). Select the place where easy drain condensated coagulated water, and easy connect with
outdoor unit.
(6). Make sure that there are enough space for care and maintenance. Make sure that the
weight between the indoor unit and ground is above
98in (
2500mm
)
.
(7). When installing the steeve bolt, check if the install place can stand the weight 4 times of the
unit’s. If not, reinforce before installation. (Refer to the install cardboard and find where should be
reinforced)
Note!
There will be lots of lampblack and dust stick on the acentric, heat exchanger and water pump
in dining room and kitchen, which would reduce the capacity of heat exchanger, lead water leakage
and abnormal operation of the water pump.
The following treatment should be taken under this
circumstance:
(8). Ensure that the smoke trap above cooker has enough capacity to obviate lampblack to
prevent the indraft of the lampblack by the air conditioner.
(9). Keep the air conditioner far from the kitchen so that the lampblack would not be indraft by
the air conditioner.
