CH A1.5, Руководство пользователя

Страница: 37 / 43

USB flash drive with a valid set of firmware must be inserted in
the back panel USB port
RESET ALL SETTINGS Reset None Selecting 'Reset' returns the A1.5 to its factory settings.
SERIAL NUMBER Serial number None Serial number indicates the serial number of the A1.5. Format is
xxxx10nn. This parameter is read only.
SHORTCUTS Default shortcuts None Selecting 'Default Mapping' returns the A1.5's Shortcuts to their
factory settings. Factory settings are detailed in the Specifications
section.
PROTECTION Disabled
Enabled
None Output short-circuit, output-DC, over-heat and amplifier-fault
detection circuitry protect both the amplifier and the connected
loudspeakers. In some regions of the world, the power
distribution grid can be so polluted that spurious power grid noise
can trig false error, thus muting or powering down the amplifier.
In such extreme cases, and if it is of major importance that the
A1.5 runs uninterrupted, protections can be temporary disabled
by the end user, at his own risk.
NETWORK
KNOWLEDGE
Reset None Clears the A1.5's memory of other CH Precision devices it has
discovered through the TCP/UDP proprietary protocol.
Details of FACTORY SETTINGS menu parameters
4.3.1.5 INSTALLED OPTIONS
The A1.5 SETUP >> OPTIONS menu provides read-only information about
installed slot-in boards. Details are:
- ANALOG IN 1:
- ANALOG IN 2:
Input board installed in Slot 1
Input board installed in Slot 2
Each slot indicates the type of board it handles. A '-' indicates that the slot is
currently unpopulated.
The following table details the parameters of the INSTALLED OPTIONS menu:
PARAMETER PARAMETER VALUES REQUIRED OPTIONS REMARKS
ANALOG IN 1, 2 Analog in left, Analog in right, - At least 1x ANALOG_IN parameters are Read Only
Details of INSTALLED OPTIONS menu parameters
Rev 1.0 A1.5 User Manual 37