T
R
O
U
B
L
E
S
H
O
O
T
IN
G
O
P
E
R
A
T
IO
N
A
S
S
E
M
B
L
Y
/
I
N
S
T
A
L
L
A
T
IO
N
S
A
F
E
T
Y
/
S
P
E
C
IF
IC
A
T
IO
N
S
G
E
T
T
IN
G
S
T
A
R
T
E
D
6
M
A
IN
T
E
N
A
N
C
E
/
R
E
P
A
IR
ASSEMBLY/INSTALLATION
Lifting and setting up your machine
Make certain that slings, cables, chains,
forklifts or other load suspending gear or
machines used to move this unit are properly rated to
handle the weight. The machine is extremely heavy.
The machine must be properly secured
and anchored before use. Make sure that
it is supported equally on all four corners. Failure to comply
may result in the machine twisting and causing binds in the
working table.
1. Unwrap the hydraulic station from packaging. The hose
should already be attached to the hydraulic cylinder. If not,
reattach it.
2. Insert the handle into either of receivers as shown below.
This can be changed at any time, since the bar is not
secured.
Machine dimensions
The following figure shows the approximate dimensions of the
hydraulic press and its parts. When determining a final location
for your machine, ensure there is enough clearance for both
the operator and for technicians who will service the machine.
Also,consider any larger work pieces that would extend beyond
the machine’s table and require extra space.
68”
44”
20”
Lubrication
Do not operate this machine before
lubrication and ensuring proper oil level.
Failure to comply may damage the machine.
Fill the pump with 32# or 46# hydraulic oil as shown by the fill
indications.
