CG Products XR1-E, Быстрый старт, Страница: 2 / 8

Quick start guide
1. Insert batteries or accus (6x AA Mignon) or connect a power adaptor . Set the power
switch upwards to "On". Connect an amplifier, mixer etc. to the output . Set the
attenuator switch for instrument amplifiers in the lower position "low" , for line-in input
at a mixer to the upper "high" position. Connect an instrument or microphone to the
instrument input .
2. Set the frequency selector switch on "Hi". Turn the "Frequency" knob in middle
position.Turn the bypass pot in fully right position : "
100% ". Turn the envelope and LFO
modulation knobs
,
in fully left position: " 0 ".
By turning the "Carrier Surpression" pot while listening to the oscillator tone, adjust the
tone to its minimum (≈ "
0 " on the scale; you may also use the green LED for indication).
Adjust the "Preamp" input gain controller while playing your instrument and listen for
optimal performance.
NOTE: It is not possible to eleminate the carrier (oscillator) tone completely. There will
always remain some overtone frequencies. Try to set the input pot on a high level (but
without distortion) to achieve best operation.
3. After you have detected the basic settings you can start to experiment, e.g. with different
oscillator frequencies , , ; add some frequency modulation with the LFO:
for LFO
speed and for modulation depth, or activate the envelope modulation by turning knob
clockwise, etc.etc..
2