ASSEMBLY STEPS
STEP 0
Please note some parts covers, feet, bushings (black plastic) may have been preassembled.
STEP 1
Attach base frame feet to base frames.
Grab (2) bolts [1], slip a washer [7] over each, then insert through base frame foot [A] and main
upright [C]. Add another washer [7] on the other side, then snug with a nut [8]. Feet [4] should have
been installed at the factory.
STEP 2
Install spotter arms.
Slide spotter arms [9] over main upright [C]. Bushings [2] should already be in place. Secure in
place with spotter arm lock pin (the large black knob) [5]. Note: Do not remove the plastic piece on
the tops of the spotter arms. These protect the finish from your bars.
STEP 3
Insert vertical insert.
Slip vertical insert [B] into main upright [C]. Secure with red handle pop pin [6].
Once you’re sure everything is square and level on the floor, tighten all nuts & bolts with
wrenches prior to use.
_
V.04.28.2015
2
