Ceyear 1465 Series, Руководство по программированию

Страница: 43 / 143

3 SCPI
3.3 Instrument subsystem command
36
Parameter:
<State> Boolean data is as follows:
ON | 1: modulation ON,
OFF | 0: modulation OFF.
Example: :OUTPut:MODulation 1 Set the state of the modulation main switch as ON.
Reset status: 0
Key Entry:
【
Modulation ON/OFF
】
3.3.2 FREQuency subsystem
FREQuency subsystem commands are used for controlling the general functions of RF output signal
frequency.
The following commands are used for setting operation modes:

[:SOURce]:FREQuency[:CW|FIXed] ................................................................... 36

[:SOURce]:FREQuency:MODE ........................................................................... 37

[:SOURce]:FREQuency:MULTiplier .................................................................... 37

[:SOURce]:FREQuency:OFFSet ......................................................................... 37

[:SOURce]:FREQuency:REFerence ................................................................... 38

[:SOURce]:FREQuency:REFerence:STATe ....................................................... 38

[:SOURce]:FREQuency:STEP ............................................................................ 39

[:SOURce]:FREQuency:STARt ........................................................................... 39

[:SOURce]:FREQuency:STOP ........................................................................... 40

[:SOURce]:FREQuency[:CW|FIXed]:AUTO ........................................................ 40
[:SOURce]:FREQuency[:CW|FIXed] <Frequency>
Function: This command is used for setting the output frequency of the signal generator in CW
mode. For setting other frequency modes, please refer to the command
―:FREQuency:MODE‖.
Setting format: [:SOURce]:FREQuency[:CW|FIXed] <val>
Query format: [:SOURce]:FREQuency[:CW|FIXed]?
Parameter:
<Frequency> Output frequency in CW mode.
Model Range
1465A [100kHz~3GHz]
1465B [100kHz~6GHz]
1465C [100kHz~10GHz]
1465D [100kHz~20GHz]
1465E [100kHz~40GHz]
1465H [100kHz~50GHz]
1465L [100kHz~67GHz]
Example: [:SOURce]:FREQuency[:CW|FIXed] 10GHz Set the frequency of the signal generator to
10 GHz.