8
www.telematrix.net
9600 SERIES ANALOG USER GUIDE
PROGRAMMING FLASH TIMING AND
PAUSE TIMING
Flash timing options are 100 mS through 1000 mS,
programmable in 100 mS increments . The default
Flash timing is 600 mS .
Pause timing options are 1 .0 s through 5 .0 s . The
default Pause timing is 3 .6 s .
1 . Press the Speakerphone ON/OFF key to
activate the telephone .
2 . Press the STORE key once .
3 . Program FLASH by pressing “1” for 100 mS,
“2” for 200 mS, and so on .
4 . Press STORE key again .
5 . Press FLASH key again . The long beep
means that the setting was successful .
6 . Exit programming by pressing Speaker key
again .
Note:
Use 3a from the Phone Map when
programming Flash . Use 3b when programming
Pause .
FLASH HOOK FUNCTION
The FLASH function is used to access PBX features
or Telco line features such as call waiting . The
FLASH function is a 600 mS timed line break . If
the FLASH function will be used often, store the
feature into memory located for easy access as
follows:
1 . Press Speakerphone ON/OFF key, then
press the STORE key .
2 . Press the FLASH key .
3 . Press the memory location wherein the
FLASH is to be stored .
4 . Press Speaker key to end this programming
phase .
HANDSET LOCATE KEY
The DECT Cordless Series is equipped with a
handset locator feature key located on the base .
key onto one . It allows easy access for guests to
retrieve messages . When the message waiting
lamp lights this notifies the guest that a message
is waiting . A simple press of the red OneTouch bar
connects the guest to the message center or front
desk . OneTouch also adds an additional memory
location to this telephone .
HANDSET MESSAGE RETRIEVAL
When the DECT handset is idle, pressing and
holding down dial key “1” on the DECT mobile
handset, this will dial the pre-programmed
contents of the OneTouch button on the DECT base
unit .
Programming
The telephone set must be connected to the PBX
in order to program it .
Some of these programming keys are located
under the faceplate and overlay, begin by lifting
up faceplate and overlay, by either a paperclip or
sharp pointer .
STORING A NUMBER INTO MEMORY KEYS
OR ONETOUCH KEY
Each location can store up to 24 digits in tone
mode .
Note:
A PAUSE or FLASH programmed into
memory counts as one digit when storing a
number .
1 . Press the Speakerphone ON/OFF key to
activate telephone .
2 . Press the STORE Key .
3 . Enter the number to be stored using the
numeric dial pad .
4 . Press the desired memory location wherein
the number is to be stored .
5 . If additional numbers are to be stored,
repeat steps 3 through 5 .
6 . Press Speaker key to end this programming
phase .
8
www.telematrix.net
9700 SERIES ANALOG USER GUIDE
