2
Overview
This installation guide describes how to install the Z-drive assembly onto your
autosampler.
Do these instructions apply to my autosampler?
These instructions apply to CETAC ASX-500 series autosamplers, including
(but not limited to) the ASX-520, ASX-260, ASX-130 and XLR-8.
The pictures in this guide show an ASX-520 autosampler. Your autosampler
may look different, but the instructions apply to all autosamplers with Z-drives
like the ones shown.
How does the Z-drive work?
The Z-drive is driven by a length of cable (line) which is made of PEEK tubing.
A rotor on the back of the autosampler moves the cable, which slides the probe
up and down on the Z-drive. A mounting block on the back of the autosampler
pivots back and forth to allow free motion of the cable while preventing the
cable from kinking.
How should I care for the Z-drive?
Do not allow the cable to bend sharply. Avoid pushing up on the slider or pushing
on the Z-drive cable.
Do not tighten the thumbscrews or nuts with anything other than your fingers.
Cleaning instructions and other maintenance information may be found in the
Operator's Manual
for your autosampler.
Installing the Z-Drive Assembly
Ensure the power cord is not connected before proceeding with
installation.
1
Remove autosampler from packaging materials.
2
Place the autosampler on a flat surface. Do not connect power. (
).
CAUTION
WARNING
