Installation & Maintenance Instruction
CET Group Co., Ltd.
www.cetgroupco.com
15.
Clean out the waste toner
Warning: Do not use a conventional toner vacuum!
16.
Refresh the end felts’ pile with a small flat bit screwdriver
17.
Vacuum the felts with a toner vacuum
18.
Wipe the discharge rod and the recovery blade with a clean, dry, lint free cloth
19.
Unpack the new CET drum unit rebuild kit,
CET501010
, containing:
OPC Drum (sold separately as CET101039)
PCR (sold separately as CET251040)
Cleaning Blade (sold separately as CET281033)
20.
Take out the new CET cleaning blade
21.
Reinstall the cleaning blade aligning the holes with the plastic bosses
22.
Secure the cleaning blade with two screws using a PH#2 screwdriver
23.
Make sure the corners of the cleaning blade fit into the cutouts on the end felts
24.
Clean the PCR saddles with a dry cotton swab
25.
Prepare two paper clips as shown, the smaller hook ends will be used as the PCR saddles’
temporary fixtures
26.
Reinstall the PCR saddles using a tweezers, and then secure each with the paper clips as shown
27.
Apply a small amount of conductive grease into the black PCR saddle
28.
Take out the new CET PCR
29.
Reinstall the PCR
Warning: The longer PCR shaft end must go into the black saddle
