Cervis Warrior 32 HH2S-9XL10, Руководство пользователя

Страница: 12 / 15

U101.1.0 6
3. Simultaneously press and hold buttons 3 (UP) and 4 (DOWN) for approximately 5-
seconds.
4. Release the buttons when LED A starts to blink.
5. TX/RX LED and B Selection LED will become active indicating the handheld is
attempting to locate all available Warrior receivers.
6. Once the handheld has completed its search and one or more receivers have been
found, the TX/RX LED and A Selection LED become active.
If there are no receivers available, the handheld will stay in scan mode until the handheld times
out or is turned off.
7. A detected receiver will start blinking the association LED indicator and the Horn/Light
relay is engaged to sound the horn. In order to select this receiver press button AUX 2.
TX/RX LED will start blinking rapidly indicating communication is established. The
receivers ID is now stored in the handheld memory slot.
8. If the found receiver unit is NOT the receiver desired, press A/B-AUX 1 button to scroll
through detected receivers until the desired receiver is found and blinking its association
LED indicator and pulsing the Horn/Light relay that is engaged to sound the horn. Press
button AUX 2 to select the receiver. The TX/RX LED will start blinking rapidly indicating
communication is established. The selected receiver is stored in the handheld memory
slot.
3.0
HH2S-9XL10 Handheld Factory Reset (Memory Clear)
The following steps will perform a factory reset on the handheld. Once this process is complete,
the handheld memory slot is cleared and it will not communicate with any receivers.

Note: The memory of spare handhelds from the factory will be clear upon arrival.
1. Turn on the handheld by pressing and releasing button 1 (STOP).
2. Within 1s of activating the handheld, while only LED 4 is active, simultaneously press
and release buttons 9 and 10. The LEDs will start scrolling indicating maintenance
mode.
3. Simultaneously press and hold buttons 9 and 10.
4. Press and release button 1 (STOP).
5. The handheld will turn off indicating the factory reset was successful.
A handheld that has been cleared will power up and immediately shutdown indicating that it has
no receiver in its memory.
Figure 9. HH2S-9XL10 with Numbered Buttons