Handheld Remote User Manual
2018 Cervis, Inc.
5
1.4
Standard Remote Switches
Table 1. Standard Remote Switches
Switch
Function
Description
Default
SW1 UP
SW1 DOWN
Output Control
3 position momentary or latch
Center
(no command)
SW2 UP
SW2 DOWN
Output Control
3 position momentary or latch
Center
(no command)
SW5 UP
SW5 DOWN
Output Control
3 position momentary or latch
Center
(no command)
SW6 UP
SW6 DOWN
Output Control
3 position momentary or latch
Center
(no command)
SW7 UP
SW7 DOWN
Associate
Store
3 position momentary or latch
Center
(no command)
PB1 Down
(push)
Machine Stop
(handheld disabled)
2-position maintained
Spring-loaded mushroom style
Down
(unit off)
PB1 Up
(twist-to-release)
Machine Stop
(handheld enabled)
JS1 +Y
JS1 -Y
Proportional Output Control
Proportional Output Control
Dual axis open gated joystick
Center
(no command)
JS1 +X
JS1 -X
Proportional Output Control
Proportional Output Control
Dual axis open gated joystick
Center
(no command)
Trigger
Joystick Enable
Switch Enable
Proportion Control
Spring-loaded return to full extension
Extended
(no command)
1.5
Remote LEDs
The standard PG-xH10JS handheld remote has four LEDs that are used to relay operating
status and for troubleshooting when needed.
Table 2. Handheld Remote LEDs
LED
Identifier
Color
Function
1 (top)
TX
Green
Rapid blinking during transmit/Solid when a switch is active
2
RX
Amber
Rapid blinking during receive/Solid when an output is active
3
ER
(error)
Red
Solid when ERROR condition occurs
4
(battery)
Amber
Blinking when Voltage is low or if batteries need to be replaced
Although the LEDs are shown in Table 2 and in the previous illustrations are in color on the
faceplate label, the colored LEDs are protected by the faceplate and label. The areas of the label
covering the colored LEDs are transparent allowing the LEDs when lit to be observed and used
for status and system troubleshooting.
