SmaRT BU-xH6R
U078.2.3-SmaRTxH6R_BU-R
24
If the Association is successful, the AMBER LED2 will flash. If communications are not
established following the Associate procedure, repeat until communication between the
handheld and base unit is achieved.
To Dissociate (see Figure 14)
Figure 14. XX-218 Dissociate Mode
Note: Observe LED states while performing the following procedure.
1. Remove power from the base unit (disconnect the P1 and P2 cables or turn the
source power OFF), and turn off the handheld.
2. Stand near the base unit with the handheld in a clear, unobstructed line-of-sight.
3. Press and hold
button 2
, then press and hold
button
1
. Hold both buttons
simultaneously.
4. Wait until the amber LED2 goes out.
Release the two buttons being held.
5. Press and release button B17. The GREEN LED1 and the RED LED3 turn
ON
.
6. Power up the base unit.
If dissociation is successful, green LED1 on the handheld remote will continually flash (TX),
indicating that the handheld and the base unit are not communicating
1
