SmaRT BU-xH6R
U078.2.3-SmaRTxH6R_BU-R
20
C3: BU-xH6R/MCB Remote Communication
Caution
To prevent inadvertent machine movement, be sure to
remove power from the Base Unit before attempting to
Associate or Dissociate.
To Associate (see Figure 11)
The MCB remote must be OFF and the base unit must have power removed before starting the
Association process.
Note: The Machine Stop button must be in the UP position before activating and using the
console remote.
1. Stand near the base unit with the remote
OFF
and
power removed
from the
base unit (disconnect the P1 and P2 cables or turn the source power OFF).
2. Release the
STOP
button on the MCB handheld by pulling it up.
3. Push and hold switch
SW1 UP
; then press the
Power ON
button. All four LEDs
light solid.
4. Observe the LEDs. When TX begins to blink, power up the base unit while
continuing to hold switch SW1 and the Power button. When all four LEDs light
solid, release switch SW1 and the Power Button.
A successful Association is indicated when LEDs TX and RX are rapidly blinking in unison.
