Cervis SmaRT BU-2H8D, Руководство пользователя

Страница: 20 / 27

SmaRT BU-xH8D Base Unit Family
U088.4.4-SmaRT_BU-xH8D 14
To Dissociate
In some circumstances, it may become necessary to break the communication link
—or
dissociate
—a base unit and a PTO handheld remote.
Caution
Using the following steps breaks all previously established handheld remote links.
It will be necessary to perform the Association Procedure (Appendix C1, above)
using each handheld to re-establish communication links with a base unit.
1. Remove power from the base unit.
2. Stand near the base unit in line of sight with the handheld in your hand.
3. Press and hold both the Associate button (B1) and Dissociate button (B2), see
Figure 8). The RX and ER LEDs light.
4. Continue to hold both buttons until the TX and RX LEDs light steady.
5. When the TX and RX LEDs light, release buttons B1 and B2. The ER and BA
LEDs light.

Note: If the next button is not pressed within the two-second interval, all LEDs flash
and the procedure is aborted. Restart the process to break the communication link.
6. Press and hold the Dissociate button (B2). (See Figure 8 above.) All LEDs light.
7. The TX LED begins to slowly blink. Continue to hold B2.
8. Apply power to the base unit while continuing to hold the Dissociate button.
The base unit and all previously linked handhelds begin to Dissociate communication links.
Once the process is complete, all LEDs light briefly and then go out.
9. Release the Dissociate button (B2).
The SmaRT base unit will not communicate with any handheld remote units. A handheld remote
must use the Association Procedure (Appendix C1) to re-establish a communication link with the
base unit.