Certa PowerPlus CT20VNLSGNA, Руководство пользователя, Страница: 7 / 16

Intended Use
The tool is intended for tacking of cardboard, insulating material, fabric, foils, leather and
similar materials onto wooden surfaces or materials similar to wood. It is not suitable for use
on hard surfaces (rock, concrete, masonry, bricks or steel).
LED Indicators:
The LED indicators will display the status of the power tool and charger (supplied
separately). Refer to the tables below:
Tool LED Indicator Status
Solid red Low battery.
Flashing red Nails/staples jammed.
Solid green No nails. Power tool is in dry fire protection mode.
Flashing green
Power tool is in overheat protection mode. Allow the
tool to cool down before returning to use.
Charger LED Indicator Status
Solid red Battery is charging.
Solid green Battery is fully charged.
LED Lighting
The lights on each side of the nail gun of can be turned on to provide additional lighting
during operation.
Testing the Safety Contact Pin
•
Remove all staples or nails from the cartridge.
•
Press the safety contact pin and pull the trigger. The safety contact pin and the
trigger should all move freely.
•
Reload the staples or nails to the cartridge.
•
Do not use the tool if the safety contact pin cannot move freely.
•
Place the contact pin against the workpiece and apply pressure to the tool without
pulling the trigger, the machine should not fire. Remove the tool from the
workpiece, the contact pin should spring back automatically.
•
Pull the trigger, the tool should not fire.
OPERATION