BASE WITH STAND - Instruction for assembly
•
lnsert the 5 spokes (E) in the central hub (A).
•
Introduce the supporting pole (B) into its housing at the top of the central base (A)
then secure it by tightning the screw with the weight and the washer (D) at the bot-
tom.
•
Loosen the plastic sleeve of the pedestal (B) turning it counterclockwise. lnsert the
small pedestal (C) resting it in the socket without to compress the spring inside the
pedestal (B). Fasten the small pedestal (C) on, turning the sleeve clockwise.
•
lnsert the articulated joint of the appliance onto the stud (C) and regulate its height
turning the sleeve as described at second paragraph.
BASE WITH STAND - WALL MOUNTED ARM
WALLARM – INSTRUCTION FOR ASSEMBLY
•
Set the bracket (A) in the wall; recommended height 200 cm. Max.
•
Fasten the plate (B) to the bracket (A) using the two nuts.
•
Mount the pact cover (H) on the plate (B) and fasten with the screw (I).
•
IMPORTANT: Without removing the safety clamp (C), witch withholds the articulated
part of the arm inside which the return spring is bossed, insert the arm (D) on the plate
(B)
•
After loosening the two screws (E) at the end f the arm (D), insert the pin (F) of the fork
and tighten the screws right home.
•
Only now’s it possible to remove the safety clamp, holding the apparatus with one
hand to prevent any Kick-back in the working position.
•
Connect the plug of the apparatus to the socket provided on the arm and connect up
to the electric power supply.
Should use cause an alteration in the balancing mechanism, correct it as follows: if lifting
the apparatus the counterweight tends to drop, turn clockwise the screw (G) on the elbow
of the arm clockwise, using a n.8 Allen wrench; if the hood tends to do the opposite, turn it
counter clockwise.
