3
2) QUICK SETUP
(for instant gratification)
1)
Plug your guitar using a 1/4” instrument cable into the INPUT on the right of the front panel
2)
Plug a suitable power cable from the AFD’s rear panel MAINS cable inlet to your wall power receptacle
3)
Plug the AFD into your speaker cabinet using 1/4” speaker cable
4)
Set the OUTPUT SELECTOR to the match the impedance of your speaker cabinet
5)
Set all rotary controls on the front panel to 12:00 (clock face)
6)
Set PKR control to the middle right position
7)
Set Channel to the up position
8)
Set Master at just above minimum
9)
Set front panel POWER switch in the “1” position (down position, with adjacent STANDBY switch in the “0”/up position)
for 30 seconds to allow tube filaments to warm up
10)
Set front panel STANDBY switch to “1” mode (down position)
11)
ROCK!!!!!!