Ceragon FibeAir IP-20 All-Outdoor Series, Руководство пользователя

Страница: 429 / 825

User Guide for FibeAir® IP-20 All-Outdoor Products, CeraOS 10.5
Page 429 of 825
Ceragon Proprietary and Confidential
Parameter Definition
•
MHF none – No MIPs are created.
•
MHF default – MIPs are created automatically on any service point
in the MEG’s Ethernet service.
•
MHF explicit – MIPs are created on the service points of the MEG
when a lower-level MEP exists on the service point. This option is
usually used when the operator’s domain is encompa ssed by
another domain.
•
MHF defer – No MIPs are created. Not used in the current release.
MA/MEG ID Automatically generated by the system. You can change this value.
MA/MEG Name Format Reserved for future use. In the current release, this is Char String only.
Tx Sender ID TLV content Sender ID TLV is transmitted.
Port Status TLV TX Reserved for future use. No Port Status TLV is transmitted in the CCM
frame.
Interface Status TLV TX An Interface Status TLV is transmitted in the CCM frame, indicating
the operational status of the interface on which the transmitting MEP
is configured (Up or Down).
MEP List Lists all local and remote MEPs that have been defined for the MEG.
11.7.3.4 Configuring MEPs
Each MEP is attached to a service point in an Ethernet service. The service and
service point must be configured before you configure the MEP. See
Configuring
Ethernet Service(s) .
Each MEP inherits the same VLAN, C-VLAN, or S-VLAN configuration as the service
point on which it resides. See
Configuring Service Points .
In order to set the VLAN used by CCM/LBM/LTM if the service point is defined
ambiguously (for example PIPE, Bundle-C, Bundle-S, or All-to-One), the service
point’s C -VLAN/S-VLAN parameter should not be set to N.A.
To configure a MEP, you must:
1 Add MEPs to the relevant MA/MEG. In this stage, you add both local and
remote MEPs. The only thing you define at this point is the MEP ID. See
Adding Local and Remote MEPs .
2 Configure the local MEPs. At this point, you determine which MEPs are local
MEPs. The system automatically defines the other MEPs you configured in the
previous step as remote MEPs. See
Configuring the Local MEPs .
3 Enable the Local MEPs. See Enabling Local MEPs .
Adding Local and Remote MEPs
To add a MEP to the MA/MEG:
1 In the SOAM MA/MEG page, select a MA/MEG and click
MEP List . The MEP
List page opens.